How hard can it be? I know multiple ways to make accurate HST. But apparently it’s still important to READ the DIRECTIONS.
Last night I started working on a 12-inch Kansas Troubles block for the Kansas Spirit BOM at my LQS. I read the directions – they are using the add 7/8 inch to the finished size to make the HST. I prefer to add a full inch and then trim square using my QIAD Triangle Square Up Ruler. Sure I ‘waste’ those slivers of fabric, and it takes time to trim the square, but my HSTs are significantly more accurate using this method.
I cut my squares pairing the light to the dark and make 24 HST. They are trimmed and press and measure 2 1/2” unfinished. I sew them into pairs. That’s when I discover I have a problem.
The instructions say to cut the squares 2 3/8”, not 2 7/8” squares. I should have cut my squares 2 1/2”. Further review of the pattern shows me I only need 16 HST, not the 24 I ended up with. The other 4 light and dark squares do not end up as HSTs.
So, into the orphan pile go these 24 HST units. After dinner I’ll start over on this block – paying more attention to the instructions. Good thing I don’t need it until NEXT Friday.
